...
...
|
...
Кофр оборудован роликами, ручками, крышкой, замками
|
...
3. |
...
...
4. |
...
...
|
...
...
|
...
...
...
...
...
|
...
...
...
...
...
кофра слегка наклонить на себя).
|
...
...
...
...
.
8. |
...
Удерживая робота за ложемент или за "талию", аккуратно выкатить его из кофра вместе с ложементом и фиксирующей скобой.
|
...
...
...
|
...
Отсоединить фиксирующую скобу от талии робота, открутив два барашковых винта. Винты можно закрепить в самой скобе, для этого предусмотрены резьбовые отверстия во внутренних боковых стенках скобы.
|
...
...
...
|
...
...
...
пластины и другие элементы транспортировочного кофра сложить в кофр, закрыть и зафиксировать крышку кофра и оставить кофр храниться для последующего использования при необходимости. |
| English | ||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Introduction1. Inside the case, the robot is transported in a specially designed foam mold designated to protect the robot in transit and when handled;
2. The case is equipped with wheels, handles, locks and a lid;
3. The case should be handled strictly vertically (as marked on the label), or rolled on its wheels when handled horizontally;
4. Inside the case, the robot is transported in a specially designed foam mold designated to protect the robot in transit and when handled;
5. In the mold, the robot is wrapped in protective plastic;
6. The robot is attached to the protective case by a designated removable clamp.
Unpacking the robot upon offloading the protective case1. Place the case vertically in accordance with the marking on the label;
2. Unscrew the wing bolts on all the 4 locks of the lid and disconnect the locks;
3. Remove the lid and put it aside; 4. Visually examine the robot, its constituent parts and accessories to assess its integrity or any possible damage in transit; 5. Unscrew the wing bolts fixating the clam on the wheeled side of the case. Should the bolts show resistance to manual unscrewing, put pressure on the robot on the lid side in the direction of the back, or tilt the case slightly (make sure the robot is fixated inside the case) in the direction of the wheels, that is - on the wheeled side of the case, incline the upper part of the case towards yourself;
6. Remove the carrier (fixating) plate; 7. Remove the metal pedestal out of the mold, and put it on the case’s profile to facilitate the robot’s rolling;
8. While holding the robot by the mold or by the robot’s “waist”, roll it out of the case, together with the mold and the fixating clam - with caution!
9. Remove the two elements of the mold by pulling them apart (each to its side);
10. By unscrewing two winghead screws, remove the fixating clam from the robot’s “waist”. The screws can be fixated in the clam itself; for this purpose, the clam has threaded openings on the inner side surfaces;
11. Remove the protective plastic wrap; 12. Take out of the foam mold the charging station and all the accessories (charging cords, user’s guide, the remote control etc.);
13. Place the mold elements, fixating plates and other removed constituent parts of the protective case in the case. Place the lid on top of the case and fixate it. Keep the protective case to be used for robot’s handling and transportation in the future. |